Garage Door Opener Installation in Fairview
Your garage door repair in Dallas, Fort Worth is just around the corner. But just like any other mechanical device requires regular maintenance to perform its best day-in and day-out. This includes cleaning and lubricating your garage door hinges, rollers and track on an annual basis. Cleaning your garage door repair or track is the first step. Don’t use water or other chemicals as this can cause build up and do more damage than good. Instead, use a broom to brush off any dust and debris. Be particularly careful to clean out spider webs and other insect nests that might capture other dirt and particles that can clog up the tracks and wheels.
For garage doors in consider doing this seasonally after the brown pine pollen has finished covering the ground. In other areas, the spring is a good time to do maintenance because winter vehicle traffic brings an abundance of dirt and grime into the garage.
Top reasons why you need garage door repair. This is part of a continuing series.
8. The disconnect switch was enabled
If you can hear your garage door motor running for what seems like the full amount of time it normally would take to open or close the door, but the door doesn’t move, chances are the disconnect switch has been enabled. Every garage door opener comes with a disconnect switch in case you lose power. This allows you to open or close the door manually so your car isn’t stuck in the garage until the power comes back on.
This switch is usually attached to a rope that can be pulled or a knob that can be turned to disconnect. Sometimes, this switch can accidentally come unhooked causing the door to be disconnected from the motor.
However, if you lose power and use the disconnect switch, you’ll need to reattach it to use your garage door motor to open and close your door again. Open the door all the way and then reattach this hook. Then try opening or closing the door again with your transmitter, and you should be all set. It will be easiest to reattach this hook when your car is not in the garage, as you’ll need to place a step ladder underneath the motor to reach it.
In Dallas go with the best for garage door repair
Why change your remote
Garage door openers are fairly simple mechanisms that tend to last a long time. Even if yours is still working fine, there are good reasons to consider replacing it. Newer models offer increased safety, security and convenience.
Here are some of the primary reasons why you might want to buy a new garage door opener.
Since 1993 garage door openers have been required to be equipped with a safety reversing mechanism.
This feature utilizes two sensors about six inches above floor level on both sides of the door. When any object, such as a child or pet, runs through the light beam created by these sensors while the door is closing, the door immediately stops and reverses.
If your garage door opener does not have a safety reversing feature, or if the one it does have no longer works, replacing the opener is highly recommended.
Does your garage door opener wake people up or otherwise disrupt the household because it makes so much noise? If so, a new opener will almost certainly be quieter.
The original style of garage door opener opened and closed with a chain drive. If you can see something that looks like a bicycle chain near the motor unit of your opener, consider replacing it with a screw drive or belt drive garage door opener. Even a newer model chain drive unit will likely be quieter than an older model
Posted in Dallas